The RY40860 is a single-stage design, meaning one rubber-edged auger scoops snow and also flings it out of the chute. That is the right architecture for a battery machine, because it removes a second spinning stage and keeps current draw low enough for two 5.0 Ah packs to be useful. The brushless motor wastes less energy as heat, which is where much of the runtime comes from.
A 21 inch path is the widest in this lineup alongside the 20 inch SnapFresh and WORX, and it comes with the batteries and charger in the box, which the bare-tool Greenworks listing does not. Against the 13 inch Litekon it needs roughly half the passes on the same drive. It still cannot match a two-stage machine on a heavy plow ridge, and wet slush will make the auger work hard.
Ownership is easy. There is no fuel to stabilize and no carburetor to clean, and the packs fit other tools on the same 40V platform. Store it with the packs indoors, wipe the auger edge dry after use, and watch the scraper bar for wear if you clear a rough surface.
What works
- Two 5.0 Ah packs and charger in the box
- Widest single-stage path in this lineup
- Brushless motor stretches pack runtime
- Shares packs with the 40V tool platform
Watch out for
- Single-stage head struggles on plow ridge
- Packs lose capacity in deep cold
- Not suited to gravel or uneven surfaces
Spec sheet
- Voltage
- 40V
- Clearing width
- 21 in.
- Type
- Single-stage
- Packs included
- Two 5.0 Ah
- Motor
- Brushless





