Best Cordless Lawn Edger and Trimmer Combos (2026)

This kit has the best balance of the pairings here because both tools are brushless. A 12 inch trimmer with 0.065 inch dual line converts to an edger and has an adjustable height shaft, and the blower moves 515 CFM, which is more than the other blowers in this guide. A single 3.0Ah battery runs both.

Brushless motors on a small 24V platform mean longer runtime per charge and less heat. For a typical lot, the order of work is trim, edge and blow, and the 3.0Ah pack is large enough to finish that in one go. The trimmer is a light-duty tool with thin line, so it suits lawn edges and weeds rather than brush.

The 24V platform is smaller than the 40V line, so the tool range is narrower, but both tools in the kit are well matched to it. Keep the blower intake clear, replace the line before it shortens and store the battery indoors. If you want a single box that handles an average suburban yard, this is the one. A useful routine is to trim first, blow second and leave the edging for last, because the edger throws the most dirt. One 3.0Ah pack will do all three on a typical lot if you work quickly and keep the head clear.

Greenworks pairs a 12 inch auto-feed trimmer with a blower that moves 390 CFM at up to 110 mph, which is enough to lift wet leaves off concrete. The listing says the trimmer can slice through weeds up to 1 inch thick and the head carries a 3-year warranty, a specific commitment that few small trimmers offer.

What makes it useful for overgrown edges is the combination of the blower and the trimmer: after cutting back a border, the blower clears the clippings and the drive stays clean. The 40V battery is the older, widely sold platform, so spares and other tools are easy to find.

The pack is only 2.0Ah, which is small for both tools, so plan to work in two stages with a recharge, or buy a second battery. The trimmer's thin 0.065 inch line limits it to medium growth. Clean the blower intake and check the line before each session. Cruise control on the blower lets you hold the trigger at a steady speed without tiring your finger, which matters when you are clearing a long driveway. Treat the warranty claim as a good sign but read the terms, since head warranties usually exclude line wear.

The WG928 is a straightforward two-tool kit. A 12 inch trimmer converts to an edger by pivoting the head, and push-button Command Feed advances line on demand, so you never bump the head. A 360 CFM blower handles the clean-up.

It is a lower-powered system than the Greenworks kits, with a smaller blower and a 20V battery, so it suits small lawns and short edging jobs. The advantage is the price and the push-button feed, which makes line management the easiest of any kit here.

The Worx 20V pack is shared across a wide range of the brand's tools, so adding a hedge trimmer later needs no new battery. Pivot the head only when the motor is stopped, wipe the pivot after use and store the pack indoors. The head tilts 90 degrees, which also helps on slopes and under low shrubs where a straight shaft is awkward. If your lawn has a lot of bank, that tilt is worth more than a few extra CFM of blower.

The LCC221 is the smallest kit in the guide. A 10 inch trimmer converts to an edger, has an adjustable height handle with a soft grip and an automatic feed spool that continuously feeds line. A sweeper completes the pair.

A 10 inch swath is narrow, so it covers less ground than the 12 inch kits, but it is the easiest to steer around beds and fence lines. A sweeper is a better partner than a blower for a small paved area, because it moves debris without scattering it.

The cost of being small is power: it is a tool for lawn edges and light weeds. Wipe the head after use, check the line before each session and store the battery indoors. Adjust the handle height before you start, because a tool set too low or too high is what makes a light trimmer feel heavy. Keep the sweeper brush clear of twigs, which jam it more often than leaves do.

This kit adds a second battery to the same idea. The trimmer converts to a wheeled edger for precise borders and an automatic line feed system supplies line as needed, and the sweeper clears debris afterwards. Two batteries and a charger are in the box.

The second battery is the key difference from the LCC221: you can trim and edge with the first and sweep with the second, or swap when the first runs low. It makes a bigger practical difference than any spec on the trimmer.

It is a light 20V system, so keep the expectations to lawn edges. Clean the head and the sweeper nozzle after use and store the batteries away from cold sheds. Charging one pack while using the other keeps the whole kit available for a full afternoon of yard work. Mark the two packs so you rotate them evenly and they age together.

A blade edger cuts a clean vertical edge into the turf, which a string head set on its side only imitates. This one has an 8.8 inch blade, three depth settings at 1, 1.25 and 1.5 inches, and a 4000 mAh battery driving it at up to 3,200 RPM.

The depth setting is the most useful feature, because it lets you match the blade to grass height, soil hardness and the line you want. A deeper setting cuts a distinct trench along a path, while the shallow setting just tidies the edge.

It is a single-purpose tool, not a combo, so it belongs here as the partner to a trimmer rather than a replacement. Use it with any of the kits above for a driveway or pavers. Clear soil from the blade after each session and keep it dry. Walk the line first and pick up stones, because a blade that hits a rock loses its edge and can kick the stone out sideways. Wear eye protection and close shoes, since an edger throws soil and grit at ankle height.