One 50 amp twist-lock inlet feeds six GFCI-protected 120 volt duplex outlets and one 120/240 volt 30 amp locking outlet. Each receptacle has its own overload protection and ground-fault protection, so a fault on a single tool trips only that outlet.
That per-outlet protection is what sets it apart from simpler boxes. A single GFCI on the inlet drops every tool on the site when one trips, while individually protected outlets let the rest of the crew keep working. The 30 amp locking outlet lets you daisy-chain a second box or feed a sub-cord.
A heavy-duty frame guards the box against being dragged and dropped. Keep the rubber covers shut when not in use, test every GFCI with its test button at the start of each day and store the box off the ground in the wet season. A tidy habit is to label each cord with the tool it feeds, so a tripped outlet leads you straight to the load that caused it. Because the box is large, carry it by the frame, not by the cords, which strains the inlet over time.
What works
- Per-outlet GFCI and overload protection
- Six duplexes plus a 30A 120/240V outlet
- 50A inlet matches large generators
- Heavy-duty frame and corrosion-resistant case
Watch out for
- Large and heavy to carry
- Needs a 50A generator outlet and cord
Spec sheet
- Inlet
- 50A twist-lock
- Outlets
- Six 120V GFCI duplexes
- Extra
- One 120/240V 30A locking outlet
- Protection
- Per-outlet overload and GFCI
- Enclosure
- Corrosion-resistant, heavy-duty frame







