The panel is rated for 30 amps at 120 volts and supports up to six circuits, each with a manual selector that moves it between utility and generator. The selector is what makes the design safe: a circuit is on one source or the other, never both.
At 120 volts it carries roughly 3,600 watts at most, which covers a fridge, a freezer, a furnace blower, a handful of lights and a router with room to spare. It does not serve a 240 volt well pump, which is the clearest dividing line between this model and the 120/240V sibling below.
UL listing is stated in the listing, and the setup is simple to explain to a family member. Keep a printed legend of the six circuits beside the panel, and run the generator under load every few months to prove that the inlet, the cord and the switches all work. A sticky selector found on a test day is far easier to fix than one found in an outage. It also helps to decide, in daylight, the order in which you will bring loads onto the generator: freezer first, then the furnace blower, then lights and electronics. Writing that order on the legend turns an anxious evening into a calm, repeatable routine, and it protects the generator from two motors starting at once.
What works
- UL listing supports permits and inspection
- Manual selectors prevent dual-source connection
- Six circuits cover a typical essentials list
- Simple layout is easy to teach to family
Watch out for
- 120V only, so no 240V pumps
- Capacity is limited to about 3,600W at 120V
Spec sheet
- Amp rating
- 30A at 120V
- Circuits
- Up to 6
- Operation
- Manual selector switches
- Listing
- UL listed
- Fit
- Most portable generators





