For a bedroom, noise is the first complaint and this DREO answers it with a claimed floor of 25dB. That figure is likely for its lowest step, but a heater tuned for quiet at its gentlest setting is exactly what a sleeping room needs: a steady, low sound that fades into the background.
The 25 inch body stands upright beside a dresser or a wall, and a thermostat lets you pick a night temperature so the element cycles off for long stretches. The V0 flame-retardant housing is a useful margin in a room with soft furnishings, although it does not replace the rule about clearance.
In practice the plan is simple. Warm the room on a higher step an hour before bed, then set the thermostat a few degrees lower and let it idle. Place the tower on a hard floor, not a rug, at least three feet from the bed, and keep the cord clear of your path to the door. A tall tower beside a bed also catches an arm or a dressing gown in the dark, so put it on the side of the room away from where you step out of bed. Many sleepers prefer the heater to face a wall corner so that warm air rolls along the ceiling and settles gently, instead of blowing across the mattress, which can dry the throat and wake you with a sore mouth.
What works
- Lowest stated noise at 25dB
- Thermostat lets the heater idle at night
- V0 flame-retardant housing
- Upright body saves floor space
Watch out for
- Quiet figure applies to the low step
- No timer listed
Spec sheet
- Height
- 25 inches
- Noise claim
- As low as 25dB
- Airflow
- 11.5 ft/s
- Control
- Thermostat
- Housing
- V0 flame retardant






