The Artist Steam is the model that makes the most of the platform. Its steam system heats water to as much as 320F and promises an outlet temperature that does not drop below 210F, which is the figure that actually reaches the floor. A 22kPa motor handles the dry side, and the listing claims a runtime of up to 75 minutes on a charge.
The listing also notes that the first steam preparation takes about a minute and later starts about 45 seconds, so there is a short wait before the heat arrives. Compared with the S7 Stretch Steam you gain endurance and suction but give up the compact lay-flat design, and compared with the S6 you lose the cord. A powered drive keeps the machine rolling forward, which matters because a wet-dry unit with full tanks is heavy.
Rinse the dirty tank after every job and run the self-clean routine so grease does not coat the roller and pipe. Let the roller dry before you stand the machine upright. A hard-water home should fill with distilled water, because scale in a steam path reduces output over time, and keep the charger where you will remember to dock it.
What works
- Longest listed runtime in the Tineco range
- Outlet steam stays at or above 210F
- 22kPa suction picks up dry debris
- Powered drive reduces pushing effort
Watch out for
- Largest and heaviest of the four
- About a minute wait on the first steam start
Spec sheet
- Steam system
- HyperSteam up to 320F
- Outlet temperature
- Not below 210F
- Suction
- 22kPa
- Runtime
- Up to 75 minutes
- Drive
- 360 degree SmoothDrive




