Generac's RTSN400G3 is an automatic transfer switch designed to sense a power failure and move the load to a standby generator without anyone touching it. The listing gives a maximum rating of 60,000 watts and compatibility with standby generators from the 20 kilowatt range upward, which is the realistic partner size for a switch this large.
The NEMA 3R enclosure is built for outdoor mounting, which matters because these switches often sit near the service entrance. Compared with the manual switches below, the cost is higher and so is the complexity, because sensing, timing and control logic are part of the package. In return you get a switch that works when nobody is home and when the power fails at night.
At this level the install is a project, not a weekend job. A licensed electrician must size conductors, coordinate with the utility and pull a permit, and the generator needs a compatible control connection. Plan for periodic exercise of the system and for a service visit when the standby generator is maintained. Ask the installer how the switch behaves when utility power flickers on and off during a storm, since a good setup waits for stable power before returning the load. Compared with a manual lever, the automatic design also saves wear on a human, because nobody has to go outside in bad weather to restore power to a freezer room or a well house.
What works
- Automatic sensing needs no one at home
- 60,000 watt maximum rating is stated clearly
- NEMA 3R enclosure for outdoor mounting
- Built for whole-house standby generators
Watch out for
- Control logic adds cost and complexity
- Needs a compatible standby generator
Spec sheet
- Amp rating
- 400A
- Operation
- Automatic power sensing
- Maximum rating
- 60,000 watts
- Generator fit
- Standby units, 20 kW and up
- Enclosure
- NEMA 3R outdoor




