A 30 amp feed matches the L14-30 receptacle found on a large share of portable generators, and this panel is built around that inlet. Pre-wired and non-automatic, it lets you move twelve circuits to the generator with illuminated rocker switches that show at a glance what is live. The glowing indicators are a real convenience in a dark house, where a lever without a light is easy to misread.
Its limit is arithmetic. Thirty amps at 240 volts is about 7,200 watts, and at 120 volts about 3,600 watts per leg, so more circuits does not mean more power. The panel's value is choice: twelve slots let you prepare a larger list of useful circuits and then pick a few at a time. The listing states UL approval and broad generator compatibility.
Plan the install as an electrician's job with a permit where required. Label every rocker, write the load list and tape it inside the cover. Use the generator outdoors and away from openings, and run any heavy motor on its own before adding the rest. Test the panel under load each fall so a stuck switch shows up on a calm day.
What works
- Matches common 30A generator inlets
- Illuminated rocker switches show live circuits
- Twelve circuit slots at 120 and 240 V
- UL approval stated in the listing
Watch out for
- 30A feed caps total power
- Twelve slots invite overloading
- Needs a permit and installer
Spec sheet
- Rating
- 30 amp, 120/240 V
- Circuits
- 12 selectable
- Type
- Non-automatic, pre-wired
- Controls
- Illuminated rocker switches
- Capacity
- About 7,200 W at 240 V





