This AlorAir uses a low grain refrigerant design, often shortened to LGR. A pre-cooling stage chills the incoming air before the main evaporator, so the machine keeps pulling water when the air is already fairly dry. That is the mechanism restoration crews pay for, and it is why this model keeps working late in a drying job when ordinary compressor boxes stall.
The label needs reading with care. The 180 pints per day in the title is a saturation figure, while the 85 pints per day AHAM number is the one that predicts a normal damp room. Against the Moiswell at 200 pints, the AlorAir looks smaller on paper, but its 85 pint rating comes from a standard test condition, which makes it the most honest figure in this group. The 210 CFM fan moves enough air to push moisture out of corners, and the compact 22.8 inch length slides through a basement door that a bigger case would not.
Ownership is mostly about the pump and the coil. The pump starts on a float switch and should be checked for slime every few months, since a stuck float is the usual failure on any pump-drain machine. Vacuum the coil and wash the filter at the start of each season, and park it with several inches of clearance on every side so the fan does not recirculate its own warm exhaust. Compared with the cheaper picks, you pay for the LGR stage and a longer warranty tail, which is worth it for a flood recovery or a persistently wet crawl space.
What works
- LGR pre-cooling keeps drying as humidity falls
- Built-in pump handles drainage without a bucket
- Honest AHAM rating beside the big headline number
- Compact case fits through standard doorways
Watch out for
- Fan noise is far above a household unit
- Saturation figure in the title overstates real room output
- Overkill for a single bedroom or small closet
Spec sheet
- Rated output
- 85 pints per day, AHAM
- Saturation figure
- 180 pints per day
- Airflow
- 210 CFM
- Footprint
- 22.8 x 13.7 x 17.3 in
- Drainage
- Automatic condensate pump





