Mounting it inside the house is the unusual part. This kit is rated for indoor use and cites UL 1008, the standard that covers transfer switch equipment, so it can live in a garage or basement beside the main panel rather than on a wet outside wall. The listing says the labeled wires are prewired, which shortens the electrician's visit and reduces mislabeled circuits.
Once installed, the benefit shows up in a power failure. A 30-foot cord means the generator can sit well away from the house, which is the right distance for exhaust, and ten circuits cover a fridge, a freezer, the furnace, a sump and several lights with room left over. Compared with the 12-circuit Nature's unit, you get fewer slots but a certification tied to the transfer equipment itself.
Plan the cord storage as carefully as the switch. A heavy 50A cord that is coiled badly takes ten minutes to untangle in the rain, so hang it on a labeled hook near the door. Check the inlet and cord ends each fall for green corrosion, and pair it only with a generator whose outlet matches the 50A plug. Because the switch lives inside, a failed rocker is also easier to service than one buried in a rain-soaked outdoor box, so ask your electrician to leave a little slack in each circuit wire.
What works
- Indoor rating avoids exposure to rain and snow
- UL 1008 cited in the listing
- Includes a 30-foot generator cord
- Prewired with labeled leads for a faster install
Watch out for
- Needs indoor wall space near the panel
- 50A cord is heavy and stiff in the cold
Spec sheet
- Rating
- 50A
- Circuits
- 10 available
- Certification
- UL 1008 per listing
- Rated for
- Indoor mounting
- Cord
- 30-foot generator power cord





