Eighteen inches of pre-wired aluminum conduit is the first thing an electrician notices. It runs from the switch straight to the breaker panel connection, so the box mounts beside the panel with little extra wiring. Per the listing, it controls a single circuit during a power failure and accepts a standard grounded extension cord from the generator.
The stated limit is just as useful: the maximum generator running watts is 1,875. That number tells a buyer exactly which generator belongs behind it and prevents the common error of connecting a much larger unit to a small switch. For a gas furnace, whose blower and ignition draw a fraction of that, the headroom is comfortable.
It differs from the BOYISEN, which is built around an inlet box with a breaker, by leaning on a cord rather than a dedicated inlet. Keep that cord short and heavy and store it in the furnace room so it cannot wander. Before heating season, check the conduit fitting for tightness and make sure the furnace restarts normally after a simulated power return. A furnace that goes through its inducer and igniter sequence without a pause or a clunk is telling you the control board is happy with the generator's output.
What works
- States a 1,875 running watt generator ceiling
- Pre-wired aluminum conduit for panel connection
- Works with a standard grounded extension cord
- Established Easy/Tran product line
Watch out for
- One circuit and a low watt ceiling
- Relies on a cord rather than a weatherproof inlet
Spec sheet
- Circuits
- Single circuit
- Generator limit
- Up to 1,875 running watts
- Connection
- Standard grounded extension cord
- Leads
- 18-inch pre-wired aluminum conduit
- Family
- Easy/Tran





