PowerMax's PMTS-50 is a purpose-built RV switch, which gives it more credibility for a coach than a generic industrial relay. It automatically selects between two incoming sources and routes the chosen one to a single output, with shore power and a generator as the expected inputs. The listing also mentions backup electrical systems.
For an owner with a 50 amp coach and an Onan generator in the 5,500 watt class or above, it matches the service size, while 30 amp units do not. Against the YAURILO 50 amp unit below, it is plainer, with a less detailed listing but a more established brand in the RV trade.
The listing does not state a transfer delay, so ask the seller or read the manual before assuming one. After installation, test it by starting the generator with shore power connected, and note how long it waits before moving the load. Because the listing is short, build your own acceptance test: write down the time from generator start to the transfer click, then check that the air conditioner is still cooling afterwards and that nothing tripped. Repeat the test once a season, since a switch whose timing drifts is signalling worn contacts or a weak relay coil. A fifty amp RV switch handles serious current, so inspect its terminals at the same time.
What works
- Purpose-built for RV shore and generator sources
- Automatic selection between two inputs
- Fifty amp rating at 120/220V
- Established name in RV power
Watch out for
- Transfer delay not stated in the listing
- Listing is light on protection features
- Not a 30 amp solution
Spec sheet
- Rating
- 50 amp, 120/220V, 60Hz
- Operation
- Automatic selection between two sources
- Sources
- Shore power, generator, backup systems
- Output
- One selected source routed to the coach
- Enclosure
- Durable enclosure per listing






