The 4048 is Shurflo's high-flow RV pump, and it earns that label with a four-chamber diaphragm that raises output to 4.0 GPM without raising the 55 PSI cut-off. In a fifth wheel the benefit is practical: two fixtures can run at once and the farthest tap still gets a respectable stream. The listing also notes it self-primes up to 6 feet and can run dry without damage.
It costs more than the generic 3 GPM copies, and it asks a little more of the battery circuit than a 3.0 GPM pump. Against the DC HOUSE 3.5 GPM it is the better-supported choice, because Shurflo rebuild parts and service knowledge are widely available at RV dealers.
In a long fifth wheel, pair it with a short suction run, flexible hoses on both ports and the factory-style strainer. Put the pump low and close to the fresh tank, because a 6 ft prime limit means a high-mounted pump or a long suction line will struggle after the system has been drained for winter. Fifth wheel owners also tend to carry a lot of water, so check that the strainer sits where you can reach it without pulling a bed platform apart, because a screen you cannot reach is a screen that never gets cleaned. A pressure gauge teed into the line after the pump is an inexpensive way to confirm the pump is behaving after each service.
What works
- 4.0 GPM improves flow at the far bathroom
- 55 PSI cut-off stays inside RV plumbing limits
- Four-chamber design smooths pulsing
- Run-dry tolerant and widely serviced
Watch out for
- Costs more than copies of the 4008 design
- Draws more current than a 3.0 GPM pump
- 6 ft self-priming limit restricts mounting height
Spec sheet
- Flow
- 4.0 GPM
- Shut-off pressure
- 55 PSI
- Design
- Four-chamber diaphragm
- Self-priming
- Up to 6 ft
- Voltage
- 12V demand pump





