Little Giant built this around a vertical float switch and a thermally protected motor, and the design is very nearly a template for the category. When the float rises it starts the pump, and when the level drops it stops again. A thermal cutout protects the motor if the reservoir ever runs dry, which is the failure that kills cheap pumps most often.
The 20 foot shutoff head means water can climb about that high before flow stops, and in practice usable lift is lower than the shutoff figure. Against the smaller VCMA-15UL at 65 GPH, the 20ULS moves more water faster, which matters if a large dehumidifier sends a heavy stream. The included safety switch has signal leads that can be wired to cut the dehumidifier if the pump fails, a feature the cheapest pumps leave out.
Ownership is simple. Clean the reservoir twice a year to keep slime off the float, and use a short run of tubing with a one way check valve so water does not drain back. Mount it level, near the unit, and test the float monthly by pouring in a cup of water. Go with it when a flood would cost real money.
What works
- Thermally protected motor survives dry runs
- Safety switch can be wired to shut the unit off
- 20 ft shutoff head gives real lifting margin
- Vertical float design is proven and simple
Watch out for
- Larger body than the compact pumps
- Float needs periodic cleaning
- Pump noise is audible in a quiet room
Spec sheet
- Flow
- 80 gallons per hour
- Motor
- 1/30 HP, thermally protected
- Shutoff head
- 20 ft
- Cord
- 6 ft with plug
- Switch
- Safety switch included





