Brightown builds an 800 watt plug-in heater with a 300 watt first step, a second 800 watt step and an ECO mode. That 300 watt setting is the useful one for a crowded RV circuit, since it draws only about 2.5 amps and still takes the edge off a cool night. The unit plugs into a wall outlet and comes with a remote and an LED display.
The listing claims it warms spaces up to 100 square feet, which is a realistic figure for 800 watts at roughly 8 watts per square foot. ETL certification gives some assurance on the safety side, covering overheat and tip-over protection. Next to the 500 watt Gaiatop, it offers more headroom for cold nights and finer control.
Because it sits on the outlet, make sure the receptacle holds it firmly. Wipe the vents with a dry cloth once a month. A warm plug is the signal to stop using it and replace the unit. Run the ECO mode first in a new rig for a night or two, watch how often it cycles, and adjust the placement until it holds the bunk comfortable on the 300 watt step alone.
What works
- 300W first step draws only about 2.5 amps
- ECO mode trims energy use
- Remote and LED display for bedtime control
- ETL certified for safety
Watch out for
- 800W covers only about 100 sq ft
- Outlet mounting loads the receptacle
- Newer brand with limited history
Spec sheet
- Power steps
- 300W (P1), 800W (P2)
- Draw at 800W
- About 6.7 amps
- Modes
- ECO and timer
- Display
- LED
- Certification
- ETL certified






