Xtreme Heaters makes this unit for the exact job in the title: pushing warm air around tanks, valves and plumbing beneath a trailer or toy hauler. A PTC element heats the air and a small fan moves roughly 58 cubic feet per minute, which is enough to circulate through a closed belly pan. The thermostat switches on at 40 degrees Fahrenheit and off at 55, so it runs only when the cavity is actually cold.
At 1000 watts it draws about 8.3 amps, a modest load next to a 1500 watt room heater. It outpowers the three bilge-style heaters from the same maker, which makes it the pick for a large belly or a skirted rig with open bays. A bigger cavity needs more heat, and an undersized unit cycles constantly without gaining ground.
Place it low where air can flow past the tanks, and keep it clear of wiring and insulation. Check the fan for debris and lint at the start of each winter. Because it relies on the thermostat, confirm the sensor is not shaded by insulation.
What works
- Thermostat runs it only below 40F
- 58 CFM fan circulates air past tanks and valves
- 1000W draws about 8.3 amps
- Made for underbelly and skirted-RV use
Watch out for
- Needs a spot inside the belly and a power run
- Moves air, so it will not warm a single frozen valve on its own
- New listing with limited ownership history
Spec sheet
- Power
- 1000W
- Thermostat
- On at 40F, off at 55F
- Airflow
- 58 CFM
- Design
- Forced-air PTC
- Target
- Underbelly and skirted bays







